Investigating Shear Force and Torque of Grapevine Shoots Based on Experimental and Simulation Analysis

Authors

  • Lingxin Bu College of Mechatronic Engineering, North Minzu University, Yinchuan, Ningxia, 750021, China https://orcid.org/0000-0001-8945-7311
  • Qiangqiang Zhang School of Mechanical Engineering, Ningxia University, Yinchuan, Ningxia, 750021, China
  • Qianwen Kou College of Mechatronic Engineering, North Minzu University, Yinchuan, Ningxia, 750021, China
  • Yun Chen College of Mechatronic Engineering, North Minzu University, Yinchuan, Ningxia, 750021, China
  • Xingjia Li College of Mechatronic Engineering, North Minzu University, Yinchuan, Ningxia, 750021, China
  • Xingtao Wu College of Mechatronic Engineering, North Minzu University, Yinchuan, Ningxia, 750021, China
  • Teng Zhang College of Mechatronic Engineering, North Minzu University, Yinchuan, Ningxia, 750021, China
  • Xingrun Tang College of Mechatronic Engineering, North Minzu University, Yinchuan, Ningxia, 750021, China
  • Jipeng Wang College of Mechatronic Engineering, North Minzu University, Yinchuan, Ningxia, 750021, China
  • Li Zhao College of Mechatronic Engineering, North Minzu University, Yinchuan, Ningxia, 750021, China

Keywords:

Grapevine branches, Simulation analysis, Axial–radial compression, Three-point bending, Shear test

Abstract

Winter pruning of grapevine branches is essential vineyard management, and knowledge of the biomechanical properties of branches is crucial for effective pruning. This study analyzed the dynamic behavior of grapevine shoots through axial–radial tensile, three-point bending, and shear tests. The axial elastic modulus, the radial elastic modulus, and the flexural modulus of grapevine shoots were 797 MPa, 79.8 MPa, and 5890 MPa, respectively. A finite element model of the grapevine shoot was established using the measured data, and a three-point bending simulation was conducted. The flexural modulus value obtained from the simulation was 5700 MPa, with a deviation of 3.37% from the experimental average, demonstrating the model’s accuracy. Moreover, a mathematical regression model was developed to describe the relationship of the branch diameter with its maximum shear force and shear torque. Shear test simulations revealed the stress distribution during the shear process, with the maximum shear force and torque deviating 9.60% and 12.11%, respectively, from the experimental averages. This study provides data support for grapevine pruning automation. In the future, these findings may contribute to the development of automated mechanical pruning equipment for grapevines.

Downloads

Published

2025-06-24

How to Cite

Bu, L., Zhang, Q., Kou, Q., Chen, Y., Li, X., Wu, X., … Zhao, L. (2025). Investigating Shear Force and Torque of Grapevine Shoots Based on Experimental and Simulation Analysis. BioResources, 20(3), 6662–6679. Retrieved from https://ojs.bioresources.com/index.php/BRJ/article/view/24709

Issue

Vol. 20 No. 3 (2025)

Section

Research Article or Brief Communication